This is an excerpt from a report made to the Aviation Safety Reporting System. The narrative is written by the pilot, rather than FAA or NTSB officials. To maintain anonymity, many details, such as aircraft model or airport, are often scrubbed from the reports.
On the way home I experienced a loss of power in cruise flight at 2,500 feet msl (1,500 feet agl) near Malcom, Iowa.
I immediately ran through the emergency checklist, I applied carburetor heat, changed fuel tanks, and adjusted the mixture between full rich and lean settings. Lastly, I tried engaging the starter twice (once on each tank) and no power was restored.
I lined up on a gravel road that ran east/west (I was heading west) for landing, but as I got closer, I saw trees along the north side of the road and concluded this was not the best choice, so I went to my backup plan, which was a road running north/south, so I turned and landed on it.
The engine was at idle power with the throttle at full power. As I pulled the throttle back the engine died.
I restarted the plane and found that at full throttle I only had idle power.
My passenger and I assessed the situation and found no damage to the airplane or ourselves.
The road was two lanes with drop offs on both sides so there was nowhere to move the plane to get it off the road. We did see a turn-off into a farm field ¼ mile behind us.
We elected to leave the plane where it was and chock the wheels and go for help.
My passenger and I walked to two houses, there was no one home, but at the third house there was a family reunion going on, so we were able to get assistance.
I called the authorities to come out and block the road.
The owner of the property said we could park the plane on his property to get it off the road.
My passenger and I looked around for a way to tow it and we found a small trailer that we could strap the tail down to for movement.
Before doing this, I wanted to see if the plane would start and if I could get more power out of it so I could taxi it the ¾ mile we needed to go.
I found that full rich and full throttle gave me idle power, as soon as I pulled the mixture almost to idle cut off, the engine roared to life, and I had power.
I throttled back and taxied the plane to the farmer’s property, which cleared the road. I called the authorities back to let them know we no longer needed them to block the road. They asked where the plane was, and I gave them the farmer’s address. We never did see the authorities.
Our club’s mechanic showed up and did some test runs on the engine and experienced the same behavior as I did.
During the final engine run the engine just stopped, no engine controls were moved.
He decided to pull the carburetor off and take it home to further look at it and discuss the behavior with Central Cylinder. Once the carburetor was off debris was found in it. The debris was a foam rubber type material that is used to create a seal between the carburetor air filter and the carburetor box.
The air filter was examined, and all pieces of the debris matched up to the missing piece on the filter, so we’re confident all pieces of debris are accounted for.
The carburetor was reinstalled, but we didn’t have any safety wire or cotter pins to finish the job. That, coupled with the time of day — it would be getting dark by the time I would be coming home — the decision was made to leave the plane. It was tied down on the farmer’s property. We retrieved it after a few days.
Primary Problem: Aircraft
ACN: 1935543
Good job at flying it all the way to the ground. Same exact thing happened to my wife and I flying from the Texas coast back to Oklahoma a few years ago. The air box gasket on our C-182 came loose and got sucked up into the carburetor killing the engine. I still get chills looking back at that little miss-adventure. AOPA picked up our story and printed it in their “Never Again” column. >>>
https://www.aopa.org/news-and-media/all-news/2021/august/pilot/never-again-engine-out-at-night
“”Safety wire or cotter pins?” What were you flying, a Curtis Jenny? I flew a homebuild for years powered by a Corvair 140HP 4-carburetor flat-six boxer powerplant. It always passed FAA inspections. Those carbs were mounted by hex-head bolts with airtight gaskets. Safety wire and cotter pins sounds so Rocky & Bullwinkle .
Safety wire always. It’s a certified aircraft.
If it is a Lycoming or Continental engine in a certified aircraft the aircraft is not legally airworthy unless the carabuetor is secured with safety-wired nuts and all control linkages are secured with castellated nuts and cotter pins. Don’t forget these are updraft caraburetors that are attached to the bottom of the engine
Great read! Creating a rapid back up landing plan to the main emergency landing plan was a great example of consistent and persistent 360° situational awareness. Great aviating!
If the air filter was a Brackett. There’s an existing AD to check for this exact thing.
Good job getting it down with no damage. And subsequent decisions for moving and storing. So this report didn’t end with a bent plane.
Interesting that the carb injested foam sealant from the “airbox”.
Reading the full report it appears that this was an L5 Stinson.